HHO Bike Kit Tutorials

There are 5 items in the kit

1. Cell
2. PWM
3. clamp
4. Chemical
5. Pipe

Procedure is as follows

1.Fix the hho cell with clamp to chessi rode verticaly just before the engine block.
2. place the pwm under the seat or some where it is safe from rain or water( it is electronic part can be damaged if come in contact with water)
3. connect he yellow and black wires of pwm with hho cells two wires.
4.From other side of pwm connect the red wire on point where supply is available upon switching on the start button of bike.
5. connect the black to earth point on chessi or to the negative terminal of battery.
6. Fill the cell with distilled water with the help of a serienge ( you can get from a medical shop) once the cell is full of water, please take out 25% water from the hho cell so that when cell is working water should not come out along with gas.
7. Add 2-3 chips of chemical in water in the cell to make the distilled water conductive. you can mix the chemical before putting in the cell.
8. Now attach the rubber pipe with the hho cell from the side where water register is attached ( water register is the thick pipe connected in between the pipe to stop water bubbles travelling to air intake) this water register should remain in vertical postion above the cell.

9. now start the bike, check the other end of pipe by dipping in water, gas bubbles should start coming out of pipe. If you feel bubble are not coming , check the electrical connections. If bubbles are less, add some more chemical to the water in cell.
10. Once you find the sufficient bubbles of gas are coming out connect the pipe to air intake hose.Connecting pipe to air intake hose.
11. make a small hole in hose with the help of screw driver or soldering iron and insert the pipe in that. that’s it your hho is ready working For any more help in English please call my number